Drift guys with rack spacers

[Paul Barrett]

Probably not the best forum for this but someone may know.
When using rack spacers , how you stop the potential spacer moving out of position,

[welshpug]

lockwashers probably, or a slot machined into the rear where it meets the rack if the end of the rack has flats on it.

[composimmonite]

Pic shows they have locating lugs -

[Paul Barrett]

Ok, this for the manta, it doesn't have locating cut outs. Just flats on opposing sides so securing tabs can be located. I think a May machine some grub scres in to secure against the flats for location then use locative and some locking washers

[Paul Barrett]

Oh btw it's not for drifing, it's to restore correct geometry as I'm moving the rack down and forward. I think this combined with dropped ballpoints should correct effectively and not compromise safety which is my main issue, I don't want to cut and weld steering arms etc, but I'm happy with high strength add ons.

[Bolf]

Yea as above , Nissan racks have a notch