|
|
|
Hi I'm struggling to work out which is front face and rear from diagram. Have they got 67mm backspace which is tiny or is it the other way round which is massive? If they'd work out for me I'd have to send courier. If you can confirm backspace I'll measure tomorrow! Btw had to open fresh acct as my old email acct is dead. Thx Ian
|
|
"To Big block or not to Big block?" Thats the question!
|
|
|
|
|
Thx I'll ring him tomorrow! Cheers
|
|
"To Big block or not to Big block?" Thats the question!
|
|
|
|
Jan 30, 2014 20:48:38 GMT
|
Still need. Consider a pair of 240 front springs.
|
|
"To Big block or not to Big block?" Thats the question!
|
|
|
|
Jan 28, 2014 12:52:07 GMT
|
Just failed MOT on cracked spring. Anyone got one or a full set of lowering springs for 240? 260 springs are thicker coils than 240 so a bit stiffer. Ideally I want to lower car eventually but just need MOT for now. Thx
|
|
"To Big block or not to Big block?" Thats the question!
|
|
|
|
|
First post on this id as forum couldn't log me in on old email address. I've just bought what I was told were 8x15 Wellers. When they arrived I realized the fool was dyslexic or blind as they clearly say 7x15 near bolt holes and also on the box. So I need to buy a pair of 8's or can swap Px a pair of 7's. They are new but have paint loss from bad packaging/handling on rims. Preferred in similar condition not some rusty ole things. Please note 7's measure 8" outer rim to outer rim as beading takes up an inch. Preferably local to me in Southport as car off road at moment. Thx Ian 07791 756506
|
|
"To Big block or not to Big block?" Thats the question!
|
|