combination u-joints

[sonus]

Is there a combination u-joint cross out there that will mate a 1310 gearbox yoke to my 75mm u-joint equipped prop?

[MrSpeedy]

Not to my knowledge. Th cardan joints are always the same in both planes.
You'd need an adaptor (similar to a wheel pcd adapter) to convert one to the other

[colnerov]

Hi, you could build up a prop shaft with the appropriate fitting each end.

Colin

[sonus]

Mar 9, 2015 12:00:37 GMT colnerov said:

Hi, you could build up a prop shaft with the appropriate fitting each end.

Colin

I know, but it would be even easier to just remove the old yoke and replace it with a new correct yoke using a combination joint. I know they exist for larger series like 1310 to 1330 etc. but haven't found any that fit the 75mm and 1310 combination.

[Dez]

speak to hauser race cars, they're great with this kind of thing.

i wanted to join a 60s ford truck gearbox to a '70s f150 prop (cos it had a slider) and then to a '50s ford 9". both joins were non-square, and different at each end, and they sorted me out over the phone from my measurements no problem. it came to about £60 with a full set of seals for the 9" as well, so pretty cheap for such service too.

[sonus]

Thanks Dez, just called them and they reconed they'd be able to help