Nodiz pro zetec conversion

[Moorhen]

Just after a bit of advice guys, I've been thinking about putting a zetec engine in my escort estate either running on a Weber carb or bike carbs. I've read all sorts abouts PATS and non PATS but then come across nodiz pro. So say I buy a complete mk6 escort what wiring would I need to remove from the donor car? Am I right in thinking I wouldn't need the PATS (if equipped) anymore? Can I fit the engine in my car, wire up temperature sensor etc and then simply plug the nodiz in and it will run? Hopefully that makes sense my electrical knowledge is a bit pants! Thanks Rob.

[slammage]

basically wire up nodiz connect nodiz to crank sensor,coilpack and tps if you have it ,put 12v and earth the nodiz. should get it all up and running.

wont need PATS at all. just stick to the nodiz.

[Moorhen]

Excellent thanks mate!

[ChasR]

As said, you connect up the basics and can hook up more if you wish like the temp sensor etc.

[Moorhen]

Does that mean I can use my existing connections for starter, alternator etc? Would I need any wiring at all from the donor?

[ChasR]

The alternator and starter wiring would be unnaffected. It would only be the things that actually make the engine run. The setup manual is on their website for further details. I'd probably take the wiring for the temp sensor etc. as it'll save you hunting around for connectors elsewhere, unless you know a source. OEM connectors also seem to be quite sturdy too IME.

Considering that Nodiz IIRC doesn't use an EDIS-4 module to fire it, it looks like a great solution to me.

[Moorhen]

That's great thanks for your help. I've watched a few videos online about installing the nodiz seems very simple. Thanks again. Rob.

[rodney]

if your car is a 1300 with a coilpack and edis ignition then you can use that to run the zetec on carbs

[Moorhen]

Cheers Rodney, my estate hasn't got the coilpack etc but I have got a 1300 escort van which has so I could use that.