manta engine mounts wanted

[darcy]

manta 1800 mounts required for 16v turbo kadett, anyone know what flywheel and clutch i need to couple it to a getrag manta box?

[bstardchild]

darcy said:

manta 1800 mounts required for 16v turbo kadett, anyone know what flywheel and clutch i need to couple it to a getrag manta box?

Is it a two piece Getrag box - ie separate Bell housing and Gearbox

Is it a 6 bolt crank?

I'm not sure if the Monza Flywheel would be suitable or not - depends on which box you are using

[CR500Dom]

You need an 1800 Manta Getrag box, the 2.0 doesnt match, as far as I know there is nothing special needed clutch wise if you use the right box
HTH
Dom

[onlyrwd]

The 1.8 and 2.0 gearboxes are identical inside but the bell housing is an integral part of the case and the two are different.

[darcy]

its a 1800 box, the splines look a bigger pitch to the 16v clutch, so i know they wont mate up, the turbo clutch might do but not checked it yet

[MantaA16V]

You could use Cortina rubber engine mounts. The Calibra Turbo clutch plate is the same spline as the Manta 'box and use a Manta cover, use the turbo flywheel too. Don,t forget you will need a spigot bearing fitted into the end of the crank for the Manta input shaft to locate into.

I used the cortina mounts spaced up a bit and the Calibra turbo plate on my A Series when i fitted a 16V.

[darcy]

mantaa16v said:

You could use Cortina rubber engine mounts. The Calibra Turbo clutch plate is the same spline as the Manta 'box and use a Manta cover, use the turbo flywheel too. Don,t forget you will need a spigot bearing fitted into the end of the crank for the Manta input shaft to locate into.

I used the cortina mounts spaced up a bit and the Calibra turbo plate on my A Series when i fitted a 16V.

thanks for the info, what spigot bearing do i need? do i use the complete mounts as i don't have anything in the way of mounts at the moment,