|
|
|
May 21, 2010 16:59:47 GMT
|
|
I have fitted some new window channel to my ford truck i did some repairs on the door around the window channel.Now the glass is to tight can i sand ,rub down the edge about 2mm.It has some writting on the glass but i think its in dutch it my be toughend glass.The edge of the glass is already rounded off.Will it break.Thanks pulling my hair out here.
|
| |
Peace,Max signature height = 80px
|
|
purplevanman
Posted a lot
Way too orangey for crows
Posts: 3,829
|
|
May 21, 2010 21:01:54 GMT
|
AFAIK it is possible to grind laminated glass but not toughened, you end up with lots of little windows  Personally I would modify the hole? |
| |
|
|
|
|
|
May 21, 2010 22:16:45 GMT
|
|
As much as it'll be a pain in the backside, I'd modify the hole where the glass fits.
If the glass shatters, how difficult is it to replace?
The door should be fairly straightforward to repair by comparison.
|
| |
|
|
|
|
|
May 21, 2010 22:36:21 GMT
|
|
Yes i think i will use a hammer and a block of wood to see if i can move the door edge.Thanks all
|
| |
Peace,Max signature height = 80px
|
|
|
|
|
May 21, 2010 22:48:47 GMT
|
|
if not take it to lee glas and glazing [notts] explain you situation ,they helped me with toughened and laminated boat glass in the past , all with ground edges
|
| |
yes ,it started badly ,petered off in the middle and the least said about the end the better!!!
|
|
|
|
|
May 21, 2010 23:44:26 GMT
|
|
Hi would you have a phone number thanks
|
| |
Peace,Max signature height = 80px
|
|
