OT: Myford Lathes

ger Part of things Posts: 329	OT: Myford Lathes ger @ger
	Mar 15, 2008 14:46:59 GMT Select Post Deselect Post Link to Post Back to Top
	Hi Folks, Long shot....I'm looking for a Tailstock for my ML7....anyone got one going spare? Thanks Gerry


	Reply Quote

v8ian Posted a lot Posts: 3,763	OT: Myford Lathes v8ian @v8ian
	Mar 15, 2008 17:11:41 GMT Select Post Deselect Post Link to Post Back to Top
	They turn up on Fleabay. But I beleive they are matched to the machine for height, depends on how accurate you want to turn, fore n aft you can dial out by putting a job up in the chuck and having as much hanging out of the chuck as feasable, the job need to be of a reasonable dia to stop deflection, cut the job full length, and measure for any taper, split the difference in half, and then adjust the tailstock to suit,, than do the same procedure to check your adjustments
	Atmo V8 Power . No slicks , No gas + No bits missing . Doing it in style. Austin A35van, very different------- but still doing it in style, going to be a funmoble

	Reply Quote

jettadeluxe Guest	OT: Myford Lathesjettadeluxe @GUEST
	Mar 15, 2008 19:02:18 GMT Select Post Deselect Post Link to Post Back to Top
	'Wanted' section......?


	Reply Quote