Rover V8 EFI Plenum, manifold, thermostat housing

[Lewis]

Would anyone here have any use for an EFi plenum, intake manifold, thermostat housing and cold start injector/water temperature sender.

As far as I'm aware it's off a 3.5 EFi.

The insets in the casting on the top of the plenum housing are painted red.

They're one complete assembly at the moment and I wouldn't be looking for much for it - say 20 quid.

Just outside MK - can get a picture or two if anyone wants it.

[pimpedoutcaddy]

got a pic mate I'm very intrested

[Lewis]

Here ya go - flash makes it look dirtier than it is but could use a bit of a scrub.

[Lewis]

Inlet diameter appears to be ~65mm, by the way!

[pimpedoutcaddy]

ok i will take it can you wait till monday and would i be able to get a courrer to collect it

[Lewis]

That's no problem! I'm around all the time at the moment as well so no problem with courier

It's all boxed up too so pretty much ready to go. Do you need a weight at all?

[pimpedoutcaddy]

no all i need is name address and a contact number

[Lewis]

You have PM!

[chodjinn]

That's a flapper system, so the injectors are not standard size BTW.